Wendys Broadcast Services LTD


	Digital Hybrid, Wireless Radio Mics
	Digital Hybrid Wireless™ is a revolutionary new design that combines 24-bit digital audio with an analog FM radio link to provide outstanding audio quality and the extended operating range of the best analog wireless systems.
	£ Call For More Info
	Link To Manufacture

Receivers
Transmitters
Accessories

SRA - E01

Two-channel slot-mount Digital Hybrid Wireless® diversity receivers. The SR receiver offers two independent channels and fits into the standard video camera slots found on professional cameras. The two audio channels can feed separate inputs or can be mixed internally to feed a single input.
NOTE: Not all cameras have two audio channels enabled in the slot.

SRA 5P - E01

The SRa5P variant is equipped with an external audio output for cameras that only have one audio input in the slot. Both audio channels can be connected with external cable (MCSR/SPXLR2).
Note: An SR or SRa may be converted to an SRa5P by an authorized Lectrosonics Service Center. Contact your dealer for details.

Choose a base

SRBATTSLED-TOP	External battery powering sled

SREXT (Required)	SR End Plate for External Use
	This kit includes an output and power panel with two TA3 male, balanced outputs and a power jack with a locking connector. A 6 foot power cable is included.

SRSNY (Required)	SR End Plate for Sony Camera's
	Adapter kit for Sony camera slots, in- cludes bezel, hard- ware, spare gasket and rear panel DB15 connector wired for power and audio connections.

SRUNI (Required)	SR End Plate for Unislot Camera's
	Adapter kit for Unislot camera slots such as those provided on Ikegami and Panasonic cam- eras. Includes bezel, hardware and rear panel DB25 connec- tor wired for power and audio connec- tions.

Plug-on Transmitter with PH Power

HM-E01

Digital Hybrid Wireless system

Membrane switch control panel with LCD display

Converts microphones with XLR jacks to wireless operation

Selectable 5, 18 and 48 volt phantom power plus off position for dynamic microphones

Adjustable low frequency roll-off

256 synthesized UHF frequencies

50 mW output power

Rugged machined aluminum housing

Remote Control for SM Transmitters

RM-E

Adjust parameters of SM transmitters:Audio Input GainRF Operating FrequencyLock/Unlock Front Panel ControlsSleep Mode On/Off

LCD and membrane switch control panel

Splash-proof, machined aluminum housing

Non-corrosive, superhard finish

Extremely long battery life

Includes quick-release lanyard

The RM gives you remote control of SM Series transmitters using an audible tone deliveredthrough the lavaliere microphone attached to the unit. Operating parameters on the transmitter can be set by holding the speaker on the RM close to the microphone and pressing the pushbutton. A dweedle tone will play from the RM speaker into the microphone and the parameter on the transmitter will be set immediately.

Miniature Transmitter Switchable Power output

SMB-E01

Digital Hybrid Wireless Technology Variable

selectable power output

SMB: 50, 100mW, (Dealer Switchable)

SMDB: 50, 100, 250mW (Dealer Switchable)

Membrane switch control panel with LCD display 256 synthesized UHF frequencies

Wide input dynamic range

DSP based pilot-tone signal

Circulator/Isolator output stage

Splash-proof, machined aluminum housing Non-corrosive, superhard finish

Single Battery

Miniature Transmitter Switchable Power output with 2x AA batts

SMDB-E01

Digital Hybrid Wireless Technology Variable

selectable power output

SMB: 50, 100mW, (Dealer Switchable)

SMDB: 50, 100, 250mW (Dealer Switchable)

Membrane switch control panel with LCD display 256 synthesized UHF frequencies

Wide input dynamic range

DSP based pilot-tone signal

Circulator/Isolator output stage

Splash-proof, machined aluminum housing Non-corrosive, superhard finish

Dual Battery

Hand Held Transmitter with Cardioid Capsule

UT-E01 with VMC

50 mW RF power for long range

256 synthesized frequencies

Compatible with Digital Hybrid Wireless? and analog receivers

Power switch can be locked out or used as a mute switch

VariMic capsule with attenuator and tone controls

Rugged, ergonomically designed machined PVC housing

The UT400 Digital Hybrid Wireless is a state-of-the-art, 50mW handheld transmitter incorporating many advanced features in order to give the user a wide range of possibilities for high-quality speech and vocal performance. The proprietary VariMic element allows custom tailoring of the microphone?s frequency response, while a digitally-controlled input limiter ensures distortion-free audio over a very wide dynamic range.